Manual release procedure for CAME ATI RAM operators
To put your gate back into automatic mode
- Put your gates in the half open position
- Turn your key clockwise
- Turn isolator back on
- Press your remote control
Please upload an image of where your gate is going to be installed. This will allow us to gain understanding of what is possible at your installation site as well as any potential issues we may spot.
Max upload size: 5mb
Accepted file types: jpg, jpeg, png
The purpose of gate piers are to support gates as well as to define an entranceway. Please let us know if you plan to keep your existing piers and if you are, please select what material they are made from. Or, if you would like new or replacement piers, please select New and let us know what material you would like.
Simply let us know how high you would like your gates. From the floor to the highest point of the gate.
This measurement should be taken between the existing piers if you plan on keeping them. This measurement is indicated by the yellow arrow. If you would like us to install new piers as part of this project, please measure the total distance from where the left pier will start to where the right pier will finish and ensure you select 'New Piers' when asked later in the form. This measurement is indicated by the white arrow.